Parts for Kenmore Models 11086983810

High limit thermostat (thermostat 250 deg f (121 deg c))

With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 250 degrees Fahrenheit. The element will kick back in when the temperature drops to 190 degrees Fahrenheit. Differential of 60 degrees.

Easy Part #:: EAP11741441

Availability:: In Stock

Price:: $53.68

Screw, 8/18 x 3/8 (screw, 8-18 x 3/8)

This screw is sold individually.

Easy Part #:: EAP11746840

Availability:: In Stock

Price:: $7.40

Dryer drum seal with adhesive (seal, drum)

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

Easy Part #:: EAP970088

Availability:: In Stock

Price:: $42.24

Dryer door switch actuator spring/lever (lever, switch)

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Easy Part #:: EAP11743767

Availability:: In Stock

Price:: $10.30

Screw - 10-16 x 1 (screw, 10-16 x 3/4)

This screw is sold individually.

Easy Part #:: EAP11741409

Availability:: In Stock

Price:: $7.40

Cycling thermostat - limit 135/155 (thermostat 150 deg f (65.6 deg c) 341146 (alt.))

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

Easy Part #:: EAP11743793

Availability:: In Stock

Price:: $49.43

Drum support shaft - rear shaft with right hand threads (shaft, l.H. Thread)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Easy Part #:: EAP11753708

Availability:: In Stock

Price:: $45.18

Screw (screw, 8-18 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Easy Part #:: EAP11742721

Availability:: In Stock

Price:: $7.37

Blower wheel (wheel, blower)

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Easy Part #:: EAP11743811

Availability:: In Stock

Price:: $39.66

Cover screw (screw, 10-32 x 1/2)

Sold individually.

Easy Part #:: EAP11740701

Availability:: In Stock

Price:: $7.40

Single access panel spring retainer/clip (retainer)

Sold Individually.

Easy Part #:: EAP11741425

Availability:: In Stock

Price:: $9.09

Drive motor with threaded shaft - 120v 60hz (motor, assembly 60 hz. (nos. 24 and 29 are not included))

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

Easy Part #:: EAP334287

Availability:: In Stock

Price:: $159.02

Drum support roller shaft - right hand threads (shaft, r.H. Thread)

This shaft is for the front with right hand thread. Sold individually.

Easy Part #:: EAP11753707

Availability:: In Stock

Price:: $46.35

Push-to-start switch kit (switch, push-to-start 345775 (alt.) 348478 (alt.))

This includes the switch, brackets and hardware.

Easy Part #:: EAP334156

Availability:: No Longer Available

Motor pulley (pulley 60 hz.)

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.