11086983810 Kenmore Dryer Parts List

Single access panel clip (clip (2))

Sold individually.

Washer (washer, support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Blower housing seal (seal, cover plate)

This part seals between the blower housing and the blower housing cover.

Switch, door (switch, broken belt)

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Spring (spring, idler)

Door handle (white)

White in color.

Seal, outlet housing

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit (terminal block screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Light bulb - 120v 25w (lamp, incadescent)

This 120-volt 25-watt light bulb is approximately 2 1/2” long. It has a small, screw-in base twist lock and it is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Screw, console (screw, 8-18 (2))

Sold individually.

Clamp-motor (clamp, motor (2))

This clamp is used to secure the drive motor.

Knob spring-clip (clip, control knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Side and bottom vent kit (white)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Nut-push-in (nut, push-in (2))

Sold individually.