11088495620 Kenmore Washer Dryer Combo Parts List

Capacitor, motor start

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Screw (screw, (hex washer head))

This screw is sold individually.

Terminal block screw kit (screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Seal-shaft (seal, oil)

Transmission shaft seal.

Roller shaft washer (washer, support)

Rear leveling leg (foot, rear)

This leveling leg is sold individually.

Bearing and seal kit (bearing & seal)

This front bearing and seal kit comes with the adhesive.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Timer power resistor (resistor, fabric Master)

This part helps your dryer's timer motor work in automatic cycles.

Lid switch actuator (actuator, lid switch)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Lock, top

This is the lock clip, which is used to lock in the front panel. Sold individually.

Ring-wire (ring, retainer)

This is part of the Basket Drive and found under the Brake Lining parts.

Terminal and wire kit (terminal, tinned & brass (includes illus. 41))

Water pressure hose - cut-to-fit (hose, pressure switch)

This is the hose that tells your appliance if your tub is at the desired water level.