11088675110 Kenmore Washer Dryer Combo Parts List

Motor pulley (pulley, motor (60 hz.))

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Lid hinge pad (pad, lid hinge)

Sold individually.

Multi rib belt (belt, drive)

Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.

Inlet hose - 5 ft (hose, inlet 81339 (alt.) 366108 (alt.))

This hose can handle hot or cold water and is five feet long.

Door handle (white)

White in color.

Suspension spring - kit of 3 (suspension assembly)

This kit does NOT come with screws or bolts. Must use originals.

Support roller clip (clip)

Sold Individually.

Single motor grommet (grommet, motor)

Sold Individually.

Capacitor, motor start (capacitor, motor start (automatic washer))

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Screw (screw, 10-16 x 1/2 (front panel to side panel))

This screw is sold individually.

Terminal block screw kit (screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Water inlet hose washer (washer, inlet hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Roller shaft washer (washer, support (4))

Knob spring-clip (spring, knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (incls. Illus. 10, 11 & 12))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.