11088675310 Kenmore Washer Dryer Combo Parts List

Bearing and seal kit (bearing & seal)

This front bearing and seal kit comes with the adhesive.

Rear leveling leg (foot, rear)

This leveling leg is sold individually.

Clamp-motor (clamp, motor mounting 343481 (alt.) 685441 (alt.))

This clamp is used to secure the drive motor.

Knob spring-clip (spring, knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Timer power resistor (power resistor & shield)

This part helps your dryer's timer motor work in automatic cycles.

Switch, main drive motor

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Thermostat heater (heater, thermostat)

This part is 120V and 3 watts.

Lock, top

This is the lock clip, which is used to lock in the front panel. Sold individually.

Lid switch actuator (actuator, lid switch)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Terminal and wire kit (terminal, tinned & brass (includes illus. 41))

Ring, spin tube support

Used with clutch.

Seal-door (seal, door)

Adhesive sold separately.

Clip (clip, pressure switch hose)

Wiring harness clip.

Screw (screw, 8-32 x 1/4 (motor ground))

This screw is sold individually. Size: 8-32 x 1/4 inch.