11088675700 Kenmore Washer Dryer Combo Parts List

Screw, 8-18 x 1/2 (screw, tapping)

This screw is sold individually.

Motor pulley (pulley, motor (60 hz.))

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Lid hinge pad (pad, lid hinge)

Sold individually.

Multi rib belt (belt, drive)

Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.

Inlet hose - 5 ft (hose, inlet)

This hose can handle hot or cold water and is five feet long.

Door handle (white)

White in color.

Washer gear case cover seal (seal, gearcase cover)

This part prevents the agitator shaft from leaking oil onto the transmission.

Support roller clip (clip)

Sold Individually.

Single motor grommet (grommet, motor)

Sold Individually.

Neutral drain kit (neutral, assembly)

Oil seal kit for gearcase input shaft (seal, thrust plug)

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Capacitor, motor start (capacitor, motor start (automatic washer))

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Screw (screw, 10-16 x 1/2 (front panel to side panel))

This screw is sold individually.

Terminal block screw kit (screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Water inlet hose washer (washer, inlet hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.