11088675700 Kenmore Washer Dryer Combo Parts List

Seal-shaft (seal, oil)

Transmission shaft seal.

Roller shaft washer (washer, support)

Knob spring-clip (spring, knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (incls. Illus. 10, 11, & 12))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Rear leveling leg (foot, rear)

This leveling leg is sold individually.

Bearing and seal kit (bearing & seal)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clamp, motor mounting)

This clamp is used to secure the drive motor.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Timer power resistor (power resistor & shield)

This part helps your dryer's timer motor work in automatic cycles.

Thermostat heater (heater, thermostat)

This part is 120V and 3 watts.

Shaft, agitator (complete) (gear, agitator)

This kit is used for direct drive washing machines and is found inside the gearcase.

Lid switch actuator (actuator, lid switch)

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

Lock, top

This is the lock clip, which is used to lock in the front panel. Sold individually.