11088754790 Kenmore Washer Dryer Combo Parts List

Centerpost bearing and seal assembly (centerpost bearing kit (incls. Illus. 10, 11 and 12))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Bearing and seal kit (bearing and seal)

This front bearing and seal kit comes with the adhesive.

Rear leveling leg (foot, rear (2))

This leveling leg is sold individually.

Heating element - 3000w 240v (element, heater)

This element is strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used to dry the clothes in your dryer.

Clamp-motor (clamp, motor mounting (2))

This clamp is used to secure the drive motor.

Knob spring-clip (spring clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Timer power resistor (resistor)

This part helps your dryer's timer motor work in automatic cycles.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Lock, top (lock, top (2))

This is the lock clip, which is used to lock in the front panel. Sold individually.

Terminal and wire kit (terminal, tinned and brass (3) (includes illus. 41))

Ring, spin tube support

Used with clutch.

Seal-door (seal, door)

Adhesive sold separately.

Clip (clip, pressure switch hose (2))

Wiring harness clip.