11088762792 Kenmore Washer Dryer Combo Parts List

Washer, spin tube thrust

Fits under the basket drive assembly.

Inner tub filter plug kit (filter, plate)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Rear leveling leg (foot, rear (2))

This leveling leg is sold individually.

Clamp-motor (clamp, motor mounting (2))

This clamp is used to secure the drive motor.

Timer assembly, 60 hz. (timer, dryer)

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Hose clamp (clamp, hose (2))

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Timer power resistor (resistor)

This part helps your dryer's timer motor work in automatic cycles.

Lock, top (lock, top (2))

This is the lock clip, which is used to lock in the front panel. Sold individually.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Terminal and wire kit (terminal, tinned and brass (3))

Ring, spin tube support

Used with clutch.

Bracket, spring outer (l.F.)

Retainer-idler 1/4-20 x 1/16 (bolt, shoulder)

Sold individually.

Door switch and actuator kit (switch, broken belt)

This part recognizes whether the door is open or closed.