11088762793 Kenmore Washer Dryer Combo Parts List

Water inlet hose washer (washer, inlet hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Knob spring-clip (clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (includes illus. 13, 14 and 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Inner tub filter plug kit (filter, plug)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Rear leveling leg (foot, rear (2))

This leveling leg is sold individually.

Clamp-motor (clamp, motor mounting (2))

This clamp is used to secure the drive motor.

Timer assembly, 60 hz. (timer, dryer)

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Hose clamp (clamp, hose (2))

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor (switch, main drive)

Timer power resistor (resistor assembly)

This part helps your dryer's timer motor work in automatic cycles.

Gearcase oil (oil, gearcase (16 oz.))

This gearcase oil comes in a 16 Oz bottle.

Lock, top (lock, top (2))

This is the lock clip, which is used to lock in the front panel. Sold individually.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Terminal and wire kit (terminal, tinned and brass (3))