11092962100 Kenmore Washer Dryer Combo Parts List

Centerpost bearing and seal assembly (centerpost bearing kit (includes illus. 13, 14 and 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Inner tub filter plug kit (filter, plug)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Rear leveling leg (foot, rear (2))

This leveling leg is sold individually.

Clamp-motor (clamp, motor mounting)

This clamp is used to secure the drive motor.

Knob spring-clip (clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Switch, main drive motor

Hose clamp (clamp, hose (2))

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Lock, top (lock, top (2))

This is the lock clip, which is used to lock in the front panel. Sold individually.

Lens (lens, drum light)

This parts covers the bulb inside the drum.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Timer dial - white (dial (washer) white)

Terminal and wire kit (terminal, tinned and brass (3))

Ring, spin tube support

Used with clutch.

Bracket, spring outer (l.F.)