11092974100 Kenmore Washer Dryer Combo Parts List

Spring (spring, idler)

Lid switch kit (switch, lid)

The point of the lid switch is for the tub to stop spinning when the washer lid is opened.

Switch, door

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Lint screen - white (screen, lint)

This filter collects lint as it passes through the dryer vent.

Single motor grommet (grommet, motor (4))

Sold Individually.

Screw (screw and washer)

Sold individually.

Seal, outlet housing

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Water inlet hose washer (washer, inlet hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Knob spring-clip (spring clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (includes illus. 13, 14 and 23))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Inner tub filter plug kit (filter, plug)

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Rear leveling leg (foot, rear (2))

This leveling leg is sold individually.

Clamp-motor (clamp, motor mounting (2))

This clamp is used to secure the drive motor.