11096502100 Kenmore Dryer Parts List

Cycling thermostat - limit 135/155 (thermostat, 150f / 66f)

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

Screw

Sold individually. Lock washers are used with screws when vibration from an appliance may cause the screw to loosen. Lock washers are also used in the electrical components of an appliance to ensure an electrical connection is not lost.

Drum support shaft - rear shaft with right hand threads (shaft, l.H. Thread)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Blower wheel (wheel, blower)

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Screw (screw, no. 8 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Single access panel spring retainer/clip (retainer)

Sold Individually.

Cover screw (screw, 10-16)

Sold individually.

Motor pulley - 60 hz. (pulley, 60 hz)

Sold individually.

Drum support roller shaft - right hand threads (shaft, r.H. Thread)

This shaft is for the front with right hand thread. Sold individually.

Single access panel clip (clip (2))

Sold individually.

High limit thermostat - l295-50f (thermostat 295f (146c))

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

Leveling leg locking nut (nut, 3/8 x 16 (r.H.))

This nut is sold individually. Size: 3/8-16

Washer (washer, support)

This support washer is located on the drum roller support shaft and it helps prevent the drum roller and pulley from rubbing against the bracket they are attached to. If your dryer is making noises, it may be the support washer becoming loose on the support shaft. The manufacturer suggests replacing the support washers at the same time as the rollers. This is a genuine OEM part. Please make sure you disconnect the power to the dryer before starting your repair.

Blower housing seal (seal, cover plate)

This part seals between the blower housing and the blower housing cover.

Spring (spring, idler)