11096573900 Kenmore Dryer Parts List

Single hex head screw (screw, rear panel mounting (hex washer head) (5))

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Support roller clip (clip)

Sold Individually.

Door handle (handle, door, white)

White in color.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit

This kit includes 3 screws and 3 nuts.

Screw, console (screw, console (2))

Sold individually.

Roller shaft washer (washer, support)

Knob spring-clip (clip, control knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Clamp-motor (clamp, motor (2))

This clamp is used to secure the drive motor.

Blower motor shaft seal (seal, blower shaft)

Timer power resistor (resistor)

This part helps your dryer's timer motor work in automatic cycles.

Nut-push-in (nut, push-in (2))

Sold individually.

Hinge - right side (hinge, door, rh)

This part attaches the door to the front panel of your dryer.

Terminal and wire kit (terminal, brass and tinned (incl. Illustration 33) (3))

Multi-temperature cycling thermostat - 4 terminals (thermostat, internal bias)

This thermostat controls the internal drying temperature. Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature.