11096762700 Kenmore Dryer Parts List

Blower housing seal (seal)

This part seals between the blower housing and the blower housing cover.

Spring

Seal, outlet housing (seal)

Screw

This screw is sold individually.

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Thermal cut-off (cutoff-tml)

The thermal cut off fuse will disrupt the power flow to the drive motor when the dryer gets too hot. If your dryer will not heat properly, or will not heat at all the issue could be with a faulty or damaged thermal cut off fuse. Before you replace the faulty cut off fuse, make sure you disconnect the power from your dryer.

Stacking kit

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

Clamp-motor (motor clamp)

This clamp is used to secure the drive motor.

Side and bottom vent kit (vent kit)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Natural gas limiter (limiter)

Moisture sensor wire harness (wire harness)

Lens

This parts covers the bulb inside the drum.

Seal-door (door seal)

This is the seal between the door and the drum.

Retainer-idler 1/4-20 x 1/16 (screw)

Sold individually.

Burner tube (shutter)

Includes hood.