11097272000 Kenmore Dryer Parts List

Lint trap housing seal (seal, bulkhead to lint chute)

This seal comes with the adhesive backing.

Two-piece split ring bearing (ring, bearing)

This is a replacement bearing ring kit for your dryer. The bearing rings are found on the top and bottom lips of the dryer drum. If your dryer is unusually noisy, or the drum will not turn during operation, or if there are marks left on your clothes after a cycle, you may need to replace the bearing ring kit. The kit comes with 2 bearings, one for the top and one for the bottom of the dryer drum. Remove the front panel of your dryer to access the dryer drum for this repair. At this point you can use a pair of needle nose pliers to release the old bearing rings from the drum. Snap the new bearing rings on, and reassemble the dryer to complete your repair.

Drum roller shaft - left side (shaft, l.H.)

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

Rear drum seal kit (seal, rear drum)

This seal kit for large capacity gas and electric clothes dryers includes a seal, an adhesive, and an instructions sheet. This felt seal for the back of the drum is sewn with red thread.

Seal (seal, lint chute)

This seal comes with the adhesive backing.

Seal and bearing (seal & bearing)

This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.

Single front panel cip (clip, front panel)

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Cover screw (screw, 10-16 x 1/2)

Sold individually.

Drum support roller shaft - right side (shaft, r.H.)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Front top lock (lock, front top)

This part is used to secure the top panel to the cabinet. Sold individually.

Push-to-start switch kit (switch, push-to-start)

This includes the switch, brackets and hardware.

Seal-door (seal, door)

Screw, 8-18 x 1/2 (screw, sensor to funnel)

This screw is sold individually.

Dryer screw (screw, 11-16 x 7/8)

11-16 x 3/4 Sold individually.

Leveling leg locking nut (nut, 3/8-16)

This nut is sold individually. Size: 3/8-16