11097561420 Kenmore Dryer Parts List

Cycling thermostat - limit 135/155 (adjustable dryer cycling thermostat kit l135-155. The cycling thermostat cycles the heat on and off to regulate the air temperature.)

Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 degrees Fahrenheit. The differential of this thermostat is 20 degrees, meaning that with this thermostat, the heating element will cycle back on once the internal temperature drops by 20 degrees.

Liquid propane conversion kit (dryer lp (liquid propane) conversion kit. From natural gas to lp.)

This part converts your appliance from Natural Gas to Liquid Propane.

Push-to-start switch - 2 terminal (dryer push-to-start switch, 2-terminal. If this switch is defective, the dryer will not start. To determine if the switch is defective, use a multimet)

This part is used to start the dryer once you have selected a setting on the timer.

Drum roller shaft - left side (shaft for drum support roller, left side)

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

Rear drum seal kit (rear felt seal with adhesive)

This seal kit for large capacity gas and electric clothes dryers includes a seal, an adhesive, and an instructions sheet. This felt seal for the back of the drum is sewn with red thread.

Seal (dryer blower housing foam seal with adhesive backing.)

This seal comes with the adhesive backing.

Screw (screw with plastic washer 8-18 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Seal and bearing (front panel felt seal. No glue required the seal streches to fit.)

This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.

Single front panel cip (dryer front panel retainer clip. 1 clip per pack.)

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Cover screw (screw)

Sold individually.

Drum support roller shaft - right side (shaft for drum support roller, right side)

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Motor pulley - 60 hz. (motor pulley, 60 hertz)

Sold individually.

Spray paint - 12 oz. - white (spray paint, white, 12 ounces)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Front top lock (top panel spring clip for washers and dryers.)

This part is used to secure the top panel to the cabinet. Sold individually.

Seal-door (door gasket, gray rubber)