11098518230 Kenmore Dryer Parts List

One time use thermal fuse (fuse, thermal)

This part is a one time use thermal fuse cannot be re-set and must be replaced when continuity between the pins is no longer present.

Screw, 8-18 x 1/2 (screw (4))

This screw is sold individually.

Leveling leg locking nut (nut, 3/8-16)

This nut is sold individually. Size: 3/8-16

Multi rib belt (belt, drive)

Specifications: Length 79-1/8 inch, width 1/4 inch, 4 ribs, Flat.

Terminal block - block only (block, terminal)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Door handle (handle, door white)

White in color.

Installation screw (screw, 8-32 x 7/32 (2))

This screw is sold individually.

Cycling thermostat (thermostat, internal bias)

Cycling thermostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 145 degrees Fahrenheit and a differential of 20 degrees. Meaning that with this thermostat, the heating element will cut out at 145 degrees and cycle back on once the internal temperature drops by 20 degrees.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Roller shaft washer (washer, support)

Bearing and seal kit (seal and bearing assembly)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clamp, motor (2))

This clamp is used to secure the drive motor.

Knob spring-clip (clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Timer power resistor (resister)

This part helps your dryer's timer motor work in automatic cycles.

Lock, top

This is the lock clip, which is used to lock in the front panel. Sold individually.