11098573820 Kenmore Washer Dryer Combo Parts List

Roller shaft washer (washer, support (3))

Water inlet hose washer (washer, inlet hose (40)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (incl. 10, 11, 12))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Electrode/sensor (pad, sensor)

Also known as a Moisture Sensor.

Bearing and seal kit (bearing and seal)

This front bearing and seal kit comes with the adhesive.

Rear leveling leg (foot, rear (2))

This leveling leg is sold individually.

Clamp-motor (clamp, motor mounting (2))

This clamp is used to secure the drive motor.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Lock, top (lock, top (2))

This is the lock clip, which is used to lock in the front panel. Sold individually.

Terminal and wire kit (terminal, tinned and brass (3) (incl. 41))

Ring, spin tube support

Used with clutch.

Seal-door (seal, door)

Adhesive sold separately.

Clip (clip, pressure switch hose (2))

Wiring harness clip.