11098575100 Kenmore Washer Dryer Combo Parts List

Terminal block screw kit (screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Seal-shaft (seal, oil)

Transmission shaft seal.

Roller shaft washer (washer, support (4))

Centerpost bearing and seal assembly (centerpost bearing kit (incl. Illustrations 10, 11, 12))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Rear leveling leg (foot, rear (2))

This leveling leg is sold individually.

Bearing and seal kit (bearing & seal)

This front bearing and seal kit comes with the adhesive.

Clamp-motor (clamp, motor mounting (2) 343481(alt.) 685441 (alt.))

This clamp is used to secure the drive motor.

Hose clamp (clamp, hose)

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Switch, main drive motor

Timer power resistor (resistor)

This part helps your dryer's timer motor work in automatic cycles.

Lock, top (lock, top (2))

This is the lock clip, which is used to lock in the front panel. Sold individually.

Ring-wire (ring, retaining)

This is part of the Basket Drive and found under the Brake Lining parts.

Terminal and wire kit (terminal, tinned and brass (incl. Illustration 41) (3))

Ring, spin tube support

Used with clutch.