11098752791 Kenmore Washer Dryer Combo Parts List

Door switch (door switch assembly)

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Inlet hose - 5 ft (hose, inlet (2))

This hose can handle hot or cold water and is five feet long.

Door handle (handle, door white)

White in color.

Suspension spring - kit of 3 (suspension assembly (3))

This kit does NOT come with screws or bolts. Must use originals.

Cycling thermostat (thermostat, internal bias)

Cycling thermostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 145 degrees Fahrenheit and a differential of 20 degrees. Meaning that with this thermostat, the heating element will cut out at 145 degrees and cycle back on once the internal temperature drops by 20 degrees.

Support roller clip (clip)

Sold Individually.

Single motor grommet (grommet, motor (4))

Sold Individually.

Screw (screw and washer, lid switch shield (2))

Sold individually.

Capacitor, motor start (capacitor, motor start (automatic washer))

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit (screw kit (for terminal block))

This kit includes 3 screws and 3 nuts.

Water inlet hose washer (washer inlet hose (4))

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Roller shaft washer (washer, support (4))

Knob spring-clip (clip)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Centerpost bearing and seal assembly (centerpost bearing kit (incls. Illus. 10,11 and 12))

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.