1109975820 Kenmore Washer Dryer Combo Parts List

Inlet hose - 5 ft (5-foot-long rubber fill hose for washing machines. Used for hot or cold water.)

This hose can handle hot or cold water and is five feet long.

Door handle (door handle, white)

White in color.

Suspension spring - kit of 3 (suspension spring assembly (kit of 3 springs))

This kit does NOT come with screws or bolts. Must use originals.

Installation screw (infinite switch screw)

This screw is sold individually.

Cycling thermostat (cycling thermostat with bias heater, l145- 20f. Note: This part is normally not the cause of the dryer not heating.)

Cycling thermostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 145 degrees Fahrenheit and a differential of 20 degrees. Meaning that with this thermostat, the heating element will cut out at 145 degrees and cycle back on once the internal temperature drops by 20 degrees.

Support roller clip (push clip for support roller)

Sold Individually.

Single motor grommet (rubber grommet for motor mount stud)

Sold Individually.

Screw (screw and washer for lid switch)

Sold individually.

Screw (screw, 10-16 x 1/2)

This screw is sold individually.

Terminal block screw kit (screw and nut kit, electric dryer cord connector.)

This kit includes 3 screws and 3 nuts.

Water inlet hose washer (washer for fill hose)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Roller shaft washer (washer)

Centerpost bearing and seal assembly (centerpost bearing and seal kit for direct drive washer. The brake removal tool is needed for easy removal of your original bearing. Please see relate)

This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals.

Washer, spin tube thrust

Fits under the basket drive assembly.

Rear leveling leg (rear leveling leg with pad, washing machine)

This leveling leg is sold individually.