19585 Kenmore Dishwasher Parts List

Seal, inlet base (pump housing seal)

Ball, check (check ball in pump housing)

Water inlet valve (dishwasher water inlet valve, 3/8" fpt inlet)

This water inlet valve is intended for use with under counter style dishwashers. It has a 3/8 of an inch FPT (female pipe thread) valve and a mounting bracket. - This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Screw and washer (screw with washer)

Sold individually.

Hose clamp

Spray - almond (spray paint, almond, 12 ounces)

Terminal (male terminal connector)

Vinyl touch-up paint blue (vinyl dishrack repair touch-up, blue, 4 ounce bottl)

Pump and motor assembly

This pump and motor assembly is intended for use with some dishwashers. It comes complete with a relay and a spray nozzle. The motor included here performs 3450 revolutions per minute and carries 120 volts. Use this kit with your dishwasher manufactured in the early 1980's.

Knob-timer (timer control knob)

Pump-repar (dishwasher drain & wash impeller kit with motor shaft seal and gaskets.)

O-ring

Dishwasher door latch pin (pin for dishwasher door latch)

This pin is part of the door latch mechanism and helps make the latch pivot properly when the handle/latch is engaged.

Detergent cup seal (soap cup latch gasket)

This seals between the cup and the door so there is no leaking of water between the door.

Screw, 8-18 x 1/2 (5) (screw)