1988 Parts List

Water tube kit (tube, plastic)

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Door shelf trim retainer (refrigerator door shelf retainer clip)

This door shelf trim retainer is just over one inch long. It is all white in color and it is made entirely of plastic.

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Scoop

Screw (refrigerator screw)

Sold individually.

Screw

Sold individually. For white and almond models.

Kickplate clip (refrigerator toe grille clip)

This kickplate clip is an inch long and is made of metal. Two are needed per refrigerator.

Clear belt (belt length 25 3/8”, width 1/4”, characteristics, clear, round)

The parts specs are: 25 3/8" long and 1/4" wide.

Compression nut (nut & sleeve assembly)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Evaporator fan motor - 115v 60hz - blade not included (refrigerator evaporator fan motor)

The evaporator fan motor circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. This part is 115 volts, has a 3/16th-inch shaft and is just over three inches long. It is made of both metal and plastic, and is made up of black, white, and metallic pieces. This evaporator fan motor is a genuine OEM part. Please remember to disconnect the power to your appliance before starting the repair.

Door hinge nylon washer (washer bottom hinge)

Screw, 8-18 x 1/2 (screw)

This screw is sold individually.

6-hour defrost timer (refrigerator defrost timer)

This part may appear different than the original, but will function the same. This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

Hinge washer (spacer)

The hinge washer works in conjunction with the door hinge on the refrigerator door. This part is white in color and measures approximately 0.75” in diameter. If the refrigerator door is making noise opening and closing, you may need to replace this part. This is a genuine OEM part and is sold individually.