1988 Parts List

Ice maker water pump and motor (pump, water)

This part helps circulate water through the evaporator to form ice that will be cut into cubes.

Hose clamp

The hose clamp helps secure the hose in place on the pump to avoid the pump or hose from leaking water onto your floor. If you notice your appliance leaking you may have a crack in the hose or the clamp is loose and will need to be replaced. This part is made of metal, measures approximately 2” in diameter and sold individually. This is a genuine OEM part.

Complete ice maker kit (refrigerator ice maker assembly)

This kit comes with ducts, a water fill tube, and the hardware needed to install the icemaker. It replaces the old twist-tray style of icemaker.

Screw

This screw is sold individually.

Leveler

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

Plastic tubing inserts - 4 included (insert)

These inserts are used with 1/4 inch plastic tubing.

Hinge pin bushing (bushing upper)

This bushing is to be used with a 1/4 inch pin.

Basket glide (guide lower basket)

Defrost heater (refrigerator defrost heater)

This radiant glass defrost heater is twenty and a half inches long. It comes with an instructions sheet, and is intended for use with the freezer evaporator of some refrigerators.

Defrost evaporator pan (drain)

This defrost evaporator and water collection pan is almost sixteen inches long. It is all black in color and it is made entirely of plastic.

Speed nut (nut, speed)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Touch-up paint - almond (tuchup)

O-ring seal

This o-ring seal is well under an inch in diameter. It is all black in color and it is made entirely of rubber.

Defrost thermostat - with wire and clip (refrigerator defrost bi-metal thermostat)

This refrigerator defrost thermostat will cut out at 80 degrees Fahrenheit and kick back when the temperature drops to 15 degrees Fahrenheit.

Hinge washer

This part can be used on either side of the center door hinges for some refrigerators.