25331133303 Kenmore Refrigerator Parts List

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice from falling back into the mold. Once removed from the mold, the ice is then deposited into the ice bucket, ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The ice stripper is white in color and is approximately 9-inch long. It is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Hex head screw (screw, hex washer head, 8-15a x 0.625, low profile)

Sold individually.

Bottom air diffuser (diffuser, air - bottom)

Kickplate grille (grille/kickplate, black)

This kickplate grille is attached to the bottom of the refrigerator.

Humidity control damper (knob, humidity cont.)

This part is found on the side of some crisper pan covers. It will allow you to adjust the humidity within the crisper pan.

Light socket (socket-light/lamp)

Cover-access (cover-access, with label)

Center hinge spacer (spacer-hinge, center)

This is placed between the center hinge bracket and the refrigerator frame.

Icemaker thermal cut-off (thermal cutoff, ice maker, complete assembly)

The ice maker thermal cut off acts as a safety mechanism that will shut the ice maker off if the mold heater gets too hot. This part cannot be re-set and must be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.

Shelf grommet (grommet, shelf mtg., 1.25" - lh)

Sold individually.

Door light switch (switch-light/lamp)

Rear roller - black (roller, compressor base, rear (2))

Sold individually.

Damper control knob (knob-damper control)

This white knob accepts a D-shaped shaft.

Door handle - black (handle-door, charcoal gray, refr., w/block and screw)

Center hinge bracket (bracket-ctr. Hinge, black)