25344713101 Kenmore Refrigerator Parts List

Drawer slide - left or right side (slide)

This drawer slide supports the left or right hand side of the sliding drawer.

Screw (screw set)

10 - 32 x 0.375

Drive gear (gear)

This icemaker drive gear works in conjunction with the ejector blades. The gear helps rotate the ejector arm to push the ice from the ice maker in to the ice bin. If your ice maker is not dispensing ice you may need to replace this part. The gear is little over an inch in diameter, white, and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Ice container (container)

Screw

Sold Individually.

Panel mounting clips (clip-40 pk)

This package contains 40 mounting clips.

Defrost heater

This part is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation to keep the cooling coils from frosting over. The thermostat must be replaced when replacing the defrost heater.

Filter - drier (filter)

Refrigerant system filter/dryer.

Switch

This is a genuine light switch, which works with freezers and refrigerators.

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice from falling back into the mold. Once removed from the mold, the ice is then deposited into the ice bucket, ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The ice stripper is white in color and is approximately 9-inch long. It is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Top hinge bearing (bearing)

Nut insert (nut)

Water inlet tube (water tube)

This part connects to the water inlet valve to icemaker & in freezer door to dispenser.

Icemaker thermal cut-off (thermal as)

The ice maker thermal cut off acts as a safety mechanism that will shut the ice maker off if the mold heater gets too hot. This part cannot be re-set and must be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.

Door secondary gasket (gasket)