25353624302 Kenmore Refrigerator Parts List

Screw

This screw is sold individually.

Screw,control mtg. (screw-#8-1)

Refrigerator condenser fan motor kit (motor-conden)

This is a replacement condenser fan motor kit for your refrigerator. This six-piece kit contains foam tape, 2 screws, the fan blade, the new motor mounting bracket, and the condenser fan motor. The condenser fan motor is found in the back of the refrigerator, and it moves air across the compressor and the condenser to keep them cool. If the motor has failed, the condenser and the compressor will run hot, and this can cause the refrigerator not to cool. This is an OEM part from the manufacturer.

Drive blade

This drive blade is a little under five inches long. It is used for the icemaker of many refrigerators.

Icemaker assembly (icemaker)

This icemaker is used on newer models where the cord will plug directly in to the back of the freezer. It includes the cover, fill cup, bail arm and a four-pin plug harness.

Pan cover insert (pan insert)

Glass Only. Frame not included.

Fresh food door gasket - white (refrigerator gasket)

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Hexagonal screw (hinge screw)

Sold individually.

Dairy door

Hinge kit - left and right hinges (adjustable h)

This is the replacement hinge kit for your refrigerator. This kit contains both the left and right hinges. Each hinge is made mainly of metal and plastic and is approximately 3 inches by 3 inches. This hinge kit does not contain the mounting hardware. The adjustable hinge kit supports the refrigerator and freezer doors and allows the doors to pivot open. The hinge kit also makes it easy to level the doors. This kit is a genuine OEM part sourced directly from the manufacturer.

Basket hanger - left side (hanger base)

This freezer basket hanger, also known as a drawer slide rail, is a genuine OEM replacement part for the freezer compartment of your refridgerator. This hanger is for the left side. Pull out the front trim, glass shelf, and basket. Use a 1/4 inch nut driver to unscrew to the basket hanger. Remove the hanger and put the new one on the mounting pegs, installing the rest of the parts in reverse order.

Ice chute door (door assy-ic)

An ice chute is mounted to the interior panel and extends between the interior panel opening and the dispenser opening for transferring ice through the chute door.

Light socket (socket-lig)

Drive gear (gear)

This icemaker drive gear works in conjunction with the ejector blades. The gear helps rotate the ejector arm to push the ice from the ice maker in to the ice bin. If your ice maker is not dispensing ice you may need to replace this part. The gear is little over an inch in diameter, white, and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Adaptive defrost control board (defrost temperature control)

This part allows the refrigerator to go into defrost mode only when required and comes with the wiring harness. ***Please Note: This control will appear different than the original but will function the same.