25354364402 Kenmore Refrigerator Parts List

Light switch (switch)

This is the replacement light switch for your refrigerator. It is white in color and is approximately 2inches long and 1 inch wide. If the light is not working or stays on, you may need to replace the switch. It is an OEM part, directly from the manufacturer. Be sure to disconnect the refrigerator from the power source before you begin this repair. To remove the switch, simply use a flathead screwdriver to pop the switch out from the refrigerator wall, then disconnect the wires. Reconnect the wires to the new switch and snap it into place to complete your repair.

Button plug (plug button)

Sold individually.

Crisper pan slide clip - white (slide)

Sold Individually. One per Package.

Hinge bearing closer - freezer (hinge bearing)

Sold individually.

Water tube

Plastic tube, 5/16".

Auger nut (nut auger)

Upper freezer door bin - white (up fz dr bin)

Sold individually.

Screw

Sold individually.

Air damper control - 2 switches (damper)

This part allows the cold air from the freezer section to be aired into the fresh food section and it is controlled by the thermostat.

Bypass (filter)

You can insert this to where the filter pack would normally go if you choose not to use the filter option on your refrigerator.

Temperature sensor (sensor)

This part helps sense the temperature inside the refrigerator. If your refrigerator is too warm or not cooling properly, you may need to replace the temperature sensor, also known as a thermistor. This is a genuine OEM part. Please make sure to disconnect the power to the refrigerator before starting your repair.

Filter - drier (filter)

Refrigerant system filter/dryer.

Fresh food temperature control (temperature control)

With refrigerators/freezers they have a thermostat that helps maintain the desire temperature.

Controllr (tsd-time s)

The start relay briefly kick starts the compressor, and then shuts off as soon as the motor gets up to speed.

Ice container with auger assembly (ice container)