25357102600 Kenmore Refrigerator Parts List

Run capacitor (capacitor)

The run capacitor, with new crimp wire connectors, is attached to the compressor and is 250 volts. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is to warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Freezer upper door bin (door bin)

Sold individually.

Dispenser crusher housing (housing)

The ice crusher housing covers the ice crusher blades inside your ice container, located in the freezer. If the housing is damaged or the auger is getting jammed up and not dispensing ice, you may need to replace the ice crusher housing. This part is white in color and made of plastic. This is a genuine OEM part. Disconnect the power to the refrigerator before starting your repair.

Rear-mount ice maker assembly (icemaker kit)

This kit includes the ice maker, power cord, bail arm, and fill cup. If your ice maker is not making or dispensing ice, or you notice a leak, you may need to replace the rear-mount ice maker assembly. This ice maker mounts to the back panel in the freezer section of the side-by-side refrigerator. If you are having an issue with the arm of this kit hitting the shelf, you will have to replace the shelf. You can find the shelf by searching EAP1152582. To complete this repair, you will need a 1/4-inch nut driver and a small flat blade screwdriver.

Screw (screw-should)

Sold individually. This is a genuine part. The handle mounting shoulder screw (no.10 ab) is made for use with many refrigerators. The metal screw helps to fasten the handle assembly to the outer door panel. The handle mounting shoulder screw is sold individually. For the repair, you will need a pair of pliers.

Defrost thermostat kit (thermostat)

This kit includes the clip, leads and heat shrink.

Crisper glass insert (glass insert)

This is a replacement crisper glass insert for your refrigerator. It fits into the crisper pan frame and acts as the top of the crisper pan, as well as a shelf for food storage. Because it is made of glass, the insert can occasionally become cracked or broken, and in this case, it will need to be replaced. To replace the insert, simply slide the old insert out and replace it with the new one. The glass insert measures approximately 17.12" X 15.40", and is sold individually. This is an OEM part sourced directly from the manufacturer.

Ribbon cable harness (ribbon harness)

Used in the dispenser board area.

Evaporator fan blade (refrigerator evaporator fan blade)

If your refrigerator or freezer is too warm or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate the cold air into the refrigerator and freezer sections. The fan blade is white in color and made from plastic. This is a genuine OEM part. Please be sure to disconnect the power to your refrigerator before starting your repair.

Refrigerator lower crisper drawer (crisper pan)

Ice dispenser drum (drum-ice dis)

This part helps push the ice through the front plate to be crushed.

Screw,control mtg. (screw-#8-18)

Screw

This screw is sold individually.

Damper assembly - 115v 60hz (damper)

This part includes the seal.

Drive blade

This drive blade is a little under five inches long. It is used for the icemaker of many refrigerators.