25357687790 Kenmore Refrigerator Parts List

Light socket (socket-lig)

Handle trim snap-in lock (door handle trim)

Sold individually.

Water filter wrench (wrench-filte)

This part is only necessary if the filter housing is stuck.

Drive gear (gear)

This icemaker drive gear works in conjunction with the ejector blades. The gear helps rotate the ejector arm to push the ice from the ice maker in to the ice bin. If your ice maker is not dispensing ice you may need to replace this part. The gear is little over an inch in diameter, white, and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Hanging basket rail - left side (hanger basket)

This rail measures approximately 12.7" long.

Dual water inlet valve (water valve)

This dual water inlet valve is typically located in the back of the refrigerator. It comes with the mounting bracket.

Defrost heater

This part is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation to keep the cooling coils from frosting over.

Water reservoir tank replacement kit (water tube)

This water reservoir tank kit contains an approximately forty-two foot long water line tube, two connectors, and two screws. This is a replacement kit from the original tank which is no longer available.

Hanging basket rail - right side (hanger)

Lower storage drawer front (front-storag)

Front only. Drawer sold separately.

Drawer slide rail - left side (hanger deli)

Condenser fan motor kit (motor-conden)

This motor runs the condenser fan in your refrigerator. This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

Door shelf bar - white - cut to fit (front)

Sold individually.

Filter - drier (filter)

Refrigerant system filter/dryer.

Drawer slide track - right side (hanger deli)