25368239800 Kenmore Refrigerator Parts List

Light switch (switch)

This is the replacement light switch for your refrigerator. It is white in color and is approximately 2inches long and 1 inch wide. If the light is not working or stays on, you may need to replace the switch. It is an OEM part, directly from the manufacturer. Be sure to disconnect the refrigerator from the power source before you begin this repair. To remove the switch, simply use a flathead screwdriver to pop the switch out from the refrigerator wall, then disconnect the wires. Reconnect the wires to the new switch and snap it into place to complete your repair.

Button plug (plug button)

Sold individually.

Shelf

This freezer shelf is for refrigerators. Follow the directions in the owner's manual to install the freezer shelf in your refrigerator. Wear work gloves to protect your hands.

Screw

Sold individually.

Filter - drier (filter)

Refrigerant system filter/dryer.

Lower hinge pin (lower hi pin)

Freezer door gasket - black (freezer gasket)

This door gasket is used to seal the freezer door when closed.

Control-humidity (humidity control)

Blade-condenser fan (blade)

This is a genuine condenser fan blade, which works with refrigerators, freezers and wines and beverage coolers.

Hex head screw (hex washer head screw)

Sold individually.

Condenser fan motor (motor-conden)

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

Bottom air diffuser (diffuser-a)

Starter device (starter)

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.

Kickplate grille (grille kick plate)

This kickplate grille is attached to the bottom of the refrigerator.

Control-humidity (humidity control)