25370137993 Kenmore Refrigerator Parts List

Screw-#8-32 x 3/8 (screw)

Sold individually.

Icemaker water inlet tube (water inlet tub)

The water inlet fill tube is used to supply water to the ice maker during the fill cycle. This part is located on the back wall of your refrigerator/freezer. The fill tube is approximately 4” long and made of plastic. If the fill tube is cracked or leaking water, you will need to replace it. This is a genuine OEM part. Please remember to disconnect the power and shut off the water supply before starting your repair.

Door insulation (insulation-d)

This insulation measures 2.5" thick, 33" wide and 70" long.

Screw

Ice maker shut-off lever cam (cam)

The ice maker shut-off lever cam works in conjunction with your ice maker inside your refrigerator. The cam attaches to the drive gear inside the motor assembly. This part is white in color, made of plastic and measures approximately 2” long. Please remember to disconnect power and water to the refrigerator before starting the repair. This is a genuine OEM part.

Upper hinge bracket (bracket)

Thermostat (thermostat assembly)

The cycling thermostat controls the activation of the icemaker ejection cycle.

Water inlet tube - cut-to-fit (water inlet tube)

1/4"diameter - 93" long - plastic - cut-to fit

Pan-defrost drain (defrost drai)

Handle trim - white (handle trim)

Lower hinge pin (hinge)

Upper hinge button plug - white (plug button)

Tube (sleeve)

Plug - button hinge (plug)

Ice cube ejector (ice ejector)

The ice ejector bar is made of plastic, white in color, and is used to push the ice cubes from the ice maker into the ice bin. The bar measures approximately 9 inches long. If the ejector bar becomes broken or ice is not entering into the bin, you may need to replace the part. This is a genuine OEM part. Please make sure you disconnect the power and water supply to the refrigerator before starting your repair.