25378137892 Kenmore Refrigerator Parts List

Evaporator fan motor (motor-evap fan)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Fan motor mounting bushing (bushing-motor mtg (2))

Screw (screw #10 pan hd 8-18 x .5)

Number 10 pan head, 8 - 18 x .5 screw.

Plug button - white (plug-hole, factory test)

Crisper drawer rod support (suport-crisper rod)

This white crisper drawer rod support is a little over an inch long.

Shutoff arm spring (spring, shut-off arm)

Nut (nut, push-on)

Sold individually.

Aluminum heater strap (strap-evap/heater, aluminum)

Compressor kit (compressor-americold, rh108, w/o electricals)

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. ***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.

Grommet (grommet, shelf/rod mtg, rh)

Sold individually.

Bracket-ctr hinge (bracket-ctr hinge, almond)

Center Hinge Pin not included.

Screw (screw-ground wire 8-32 x 1/4)

Screw-#8-32 x 3/8 (screw-im mtg brkt, hex hd #8-32 x 3/8)

Sold individually.

Icemaker water inlet tube (tube-water inlet)

The water inlet fill tube is used to supply water to the ice maker during the fill cycle. This part is located on the back wall of your refrigerator/freezer. The fill tube is approximately 4” long and made of plastic. If the fill tube is cracked or leaking water, you will need to replace it. This is a genuine OEM part. Please remember to disconnect the power and shut off the water supply before starting your repair.

Screw (screw-bracket, hex washer hd, 8-32ca x 0.500)