25378296898 Kenmore Refrigerator Parts List

Light socket (socket-lig)

Drive gear (gear)

This icemaker drive gear works in conjunction with the ejector blades. The gear helps rotate the ejector arm to push the ice from the ice maker in to the ice bin. If your ice maker is not dispensing ice you may need to replace this part. The gear is little over an inch in diameter, white, and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Pan head screw (screw)

Sold Individually. Order quantity required.

Drawer slide rail - left side (hanger deli)

Condenser fan motor kit (motor-conden)

This motor runs the condenser fan in your refrigerator. This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

Filter - drier (filter)

Refrigerant system filter/dryer.

Drawer slide track - right side (hanger deli)

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice from falling back into the mold. Once removed from the mold, the ice is then deposited into the ice bucket, ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The ice stripper is white in color and is approximately 9-inch long. It is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Hex head screw (hex washer head screw)

Sold individually.

Door/light switch (switch)

This part turns the light on/off as the door opens and closes.

Crisper glass cover (insert control panel)

Glass Only. Frame sold separately.

Hinge bearing

Starter overload (starter overlay)

The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.

Icemaker thermal cut-off (thermal as)

The ice maker thermal cut off acts as a safety mechanism that will shut the ice maker off if the mold heater gets too hot. This part cannot be re-set and must be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.

Door hinge washer (hinge washer)