2539338781 Kenmore Refrigerator Parts List

Door hinge pin bearing (hinge bearing)

This white hinge pin bearing pivots the freezer and refrigerator door.

Crisper pan

Pan only. The front, or the handle part, is sold separately.

Compressor start relay (relay)

Screw

Sold individually.

Filter - drier (filter)

Refrigerant system filter/dryer.

Freezer shelf end cap (cap)

Sold Individually. These fit on the tips of the shelf to keep it from sliding forward.

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice from falling back into the mold. Once removed from the mold, the ice is then deposited into the ice bucket, ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The ice stripper is white in color and is approximately 9-inch long. It is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Freezer door gasket (freezer gasket)

This white door gasket is used to seal the freezer door when closed.

Hex head screw (hex washer head screw)

Sold individually.

Cold control thermostat (temperature control)

This cold control thermostat cycles on and off regularly to maintain a cold temperature in your refrigerator.

Door/light switch (switch)

This part turns the light on/off as the door opens and closes.

Meat pan

Screw

Sold individually.

Door hinge center pin (pin-center h)

Water valve with bracket (water valve)

The water inlet valve with bracket help supplies water to the water dispenser and ice maker in your refrigerator. If a solenoid goes bad causing no water to enter into the ice maker or dispenser, the water inlet valve will need to be replaced. The bracket on the valve measures 4 3/4”. This is a genuine OEM part. Please remember to disconnect the power and water supply before starting the repair.