36358092891 Kenmore Refrigerator Parts List

Defrost thermostat

This clip on refrigerator defrost thermostat clips on to your refrigerator's evaporator. It will cut out at 60 degrees Fahrenheit and kick back in when the temperature drops to 32 degrees Fahrenheit.

Screw - 12-24 tt ovt .900 s (12-24 screw)

Sold individually.

Dispenser water reservoir (water tank)

This in-refrigerator dispenser water reservoir tank comes with tubing. This tank stores water until the water actuator is activated and water is requested.

Dispenser door solenoid kit (solenoid)

This kit is used on the water/ice dispenser door. This part allows water/ice to be dispensed on demand.

Condenser fan motor - 115v (fan motor)

This part comes with 3 round pin connection terminals. This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

Defrost heater with thermostat (heater sensor harness)

This part assembly has 2 functions: The defrost heater keeps the cooling coils from frosting over and the thermostat senses that the heat near the cooling coils has reached the desired temperature.

Armature kit (shroud)

Dispenser grille (grill rec wh)

This white dispenser grill is located at the bottom of the ice/water dispenser.

Ice dispenser plate (plate dispenser)

Evaporator fan blade kit (fan blade)

Plastic tubing - 5/16 inch (tube)

This part is the replacement water line for your refrigerator. It is a long plastic tube, which is 5/16 of an inch in diameter. If your refrigerator is leaking, or will not dispense water or ice, you may have a damaged water line. When you replace the water line, you may want to pick up a new water tube union as well. You can use a utility knife to cut the old water line where it is damaged, and use the union to attach the new water line to the old one. This tubing is sold individually and is an OEM part.

Fill tube grommet (grommet)

This fill tube grommet is used on the icemaker.

Dual inlet water valve (water valve)

This part has screw-on connections. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Scr 8-18 tpt 1/4 (scr 8-18 tpt)

Dispenser assembly crank (drive recovery crank)