36359522997 Kenmore Refrigerator Parts List

Water valve and bracket assembly (bracket & valve asm)

This water valve assembly has been redesigned. It has a new quick connect style valve. To install: Cut original plastic nuts off tubing and gently push into valve until they stop. No other nuts or connectors needed.

Auger and ice bucket assembly (bucket & auger asm disp)

This auger and bucket assembly is used on 25 cubic feet and 27 cubic feet side by side models.

Freezer wire shelf (shelf fz)

This part is approx. 14 3 /4" L x 13 1/4" W. Sold individually.

Primary water inlet valve (water valve asm)

This part has one port and 2 solenoids and comes with a mounting bracket. The water valve is a solenoid-operated switch located at the bottom of the refrigerator. When it is energized by electrical power, water is released from the supply line through the water valve and into the compact icemaker mold.

Actuator pad (pad actuator wh)

Note: This part is now ONLY available in black.

Ice dispensing drive cup (cup drive)

Found at the end of the auger in the ice container - replace when the icemaker doesn't dispense ice.

Dairy door (door dairy)

Ice dispenser solenoid service kit (solenoid arm asm)

This kit includes 1 cube solenoid, 1 armature, 2 tooth washers and 2 1/4 hex head screws.

Freezer light shield (shield light fz)

Defrost thermostat (thermostat def)

This clip on refrigerator defrost thermostat clips on to your refrigerator's evaporator. It will cut out at 60 degrees Fahrenheit and kick back in when the temperature drops to 32 degrees Fahrenheit.

Door hinge shim (shim riser cam .093)

This is the replacement door hinge shim, or riser cam shim for your refrigerator. It is made of metal and is approximately 2 inches in length, and 1 inch in width. Your refrigerator will have a door hinge shim on each door, and each shim is sold individually. The door hinge shim will have three holes in it; one larger hole, and two smaller ones. The door hinge shim is found on the bottom of your refrigerator door, and the main reason for replacing it is if it is torn or damaged. When you are completing this repair, the door will be briefly unsupported. As a result, it is recommended to remove everything from the door to make it as light as possible, and to ensure that the items in the door don’t fall out. This is an OEM part from the manufacturer.

Screw (scr 8-18 ab hxw 3/8 s)

This screw is sold individually.

Ice bucket auger (auger helix disp)

When activated, the auger rotates and pushes ice out of the bin through the chute to the user.

Dispenser door solenoid kit (solenoid asm)

This kit is used on the water/ice dispenser door. This part allows water/ice to be dispensed on demand.

Ice bucket support - left side (ice bucket shelf l/s)

This is the ice bucket support for your refrigerator. The ice bucket support is connected to the freezer wall and supports the ice bucket. If the support is broken, the bucket may hang to one side, or it may fall out of position entirely. In either case, you will need to replace the ice bucket support. There will be a support on either side of the ice bucket, but this part is for the left side only. It is sold individually so be sure to select the part for the correct side of the bucket. This is an OEM part sourced directly from the manufacturer.