41744152401 Kenmore Washer Parts List

Dispenser drawer cover - bisque (cover)

Washer outer tub gasket (o ring) (o ring)

This tub gasket, also known as an O-ring, is located between the front and rear outer tubs to form a seal to prevent water from leaking. This is a genuine OEM part. Please make sure you disconnect the power to the washer before starting your repair.

Door boot spring (spring)

Top panel - white (panel)

Used on front-load washers and dryers.

Clip,assembly (clip)

Drive motor (motor)

This motor is used on front load washers.

Dispenser drawer conveyor (conveyor)

Idler pulley (pulley)

Hose clamp (clamp)

Inner door panel (panel)

Screw,10.9 class ,m10 x 25 mm (screw)

Water valve and dispenser assembly (dispenser assembly)

These valves are where the water supply from the house attach to the washing machine. You connect the hoses to the valve with fill hoses. The fill hoses should have screens installed in them to prevent debris from entering the valve and causing it to stick open or closed. Sometimes these valves are called mixing valves, because they essentially mix the cold and hot water together to create “warm” water. Another common term is water solenoid.

Shipping support kit (shipping bolt kit)

Screw (hinge screw)

This screw is a little under an inch long.

Clamp (clamp-tub pu)

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.