41799190100 Kenmore Washer Dryer Combo Parts List

Single clip (guide clip (4))

Sold individually.

Spin bearing (upper spin bearing)

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.

Upper spin bearing washer (washer)

The upper spin bearing washer works in conjunction with the spin bearing inside your washer. This part sits below the spin bearing. When the spin bearing washer becomes damaged there will be a metal on metal sound meaning it should be replaced. The washer measures approximately 2” in diameter and is sold individually. This is a genuine OEM part. Please remember to disconnect the water and power supply to the washer before starting this repair.

Lid strike - white (lid strike)

This part is used to activate the lid switch when the lid opens/closes.

Clamp

Clamp used for hoses.

Bracket screw (screw (2))

Sold individually.

Tension spring (torsion spring)

This spring works in conjunction with the idler pulley.

Direct drive pump (pump)

This pump sucks the water out of your washers tub with one of its valves, and drains the water into a drain hose with the other valve.

Transmission assembly (complete transmission)

This part aids in the spinning or agitating cycles.

Washer bolt (screw (2))

Holds plated on Trunion .312-18 x 1.625.

Heating element coil kit (heater assembly)

This kit includes the heating element restring coil, 2 insulators and a terminal block.

Shaft (support shaft)

Drum baffle (vane (3))

This part moves the clothes around inside your dryer and helps to direct the flow of hot during the drying cycle.

Terminal block

Snubber ring

Mounts at the base under the support.