Parts for Kenmore Models 41799190110

Door strike

The door strike works in conjunction with the dryer door. The male piece of the door strike is the piece that activates the door switch once the dryer door is closed. If your dryer won’t start, or the door won’t open/close, you may need to replace the door strike. This part is made from metal and measures approximately 1 inch. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Easy Part #:: EAP455020

Availability:: In Stock - Ships Today

Price:: $15.01

Tension idler pulley (idler arm assembly)

This idler arm assembly comes with the pulley wheel.

Easy Part #:: EAP418897

Availability:: No Longer Available

Blower wheel

This blower wheel is a genuine OEM replacement part for your dryer. The wheel can become damaged through use of the dryer, especially if the drive motor shaft, which it is attached to, becomes damaged. This repair will require some disassembly of the dryer. Make sure to disconnect the power source and wear appropriate work gloves while conducting this repair.

Easy Part #:: EAP417911

Availability:: In Stock - Ships Today

Price:: $56.90

Agitator

The agitator is used in top-loading washing machines to help move the clothes around by rotating back and forth through the detergent and water to wash them. If your agitator won’t agitate or is damaged it will need to be replaced. The agitator is approximately 19” tall with a base diameter of about 13”, white in color and made of plastic. The hub has been changed from a hex to a spline. The agitator drive block and cap must be ordered separately. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Easy Part #:: EAP446533

Availability:: In Stock - Ships Today

Price:: $86.20

Terminal block kit (terminal block)

This kit includes 3 screws and 3 terminals.

Easy Part #:: EAP419369

Availability:: On Order

Price:: $43.87

Agitator drive block (drive hub)

The agitator drive block works in conjunction with the agitator in your washing machine by rotating the agitator assembly. If your washer is noisy and not agitating, you may need to replace the drive block because it may be worn out. This part is located between the agitator and the transmission shaft, measures approximately 2” long and is made of metal. This is a genuine OEM part. Please remember to disconnect the power and water supply before beginning your repair.

Easy Part #:: EAP1152574

Availability:: In Stock - Ships Today

Price:: $53.27

Single clip (guide clip (4))

Sold individually.

Easy Part #:: EAP459782

Availability:: No Longer Available

Spin bearing (upper spin bearing)

The upper spin bearing works in conjunction with your washer. This part is located on the bottom of the outer tub where the transmission goes up through the middle of the tub. The spin bearing is used to support the transmission shaft in the drive system and allows the transmission shaft to be able to spin freely during the spin cycle. When the spin bearing goes bad it can cause noises during the spin cycle and will need to be replaced. This part is made of metal and is secured by mounting screws. The screws are not included, bearing only. This is a genuine OEM part. Please disconnect the water and power supply before starting the repair.

Easy Part #:: EAP446536

Availability:: In Stock - Ships Today

Price:: $66.20

Upper spin bearing washer (washer)

The upper spin bearing washer works in conjunction with the spin bearing inside your washer. This part sits below the spin bearing. When the spin bearing washer becomes damaged there will be a metal on metal sound meaning it should be replaced. The washer measures approximately 2” in diameter and is sold individually. This is a genuine OEM part. Please remember to disconnect the water and power supply to the washer before starting this repair.