41799390130 Kenmore Washer Dryer Combo Parts List

Vertical spring - short (spring, vertical, short)

This short vertical suspension spring is used to support and balance the outer tub of your washer during unbalanced loads. If the spring is broken it will cause the washer to be off balance during the spin cycle which will make the washer noisy. This is a genuine OEM part and is sold individually. Please check your washer to see how many springs are required for your model before placing the order. Please make sure you disconnect the power and the water supply to your washer before starting the repair.

Bleach dispenser (dispenser, bleach)

Horizontal spring (spring, horizontal)

Agitator cap seal (seal)

Pad (pad, legs)

Trunnion plate (lockplate)

Locking Plate.

Screw

This screw is a little over an inch long.

Blower housing assembly (front, blower housing)

Suspension spring - long (spring, vertical)

Sold individually.

Blower housing foam seal (seal)

Upper lip seal (seal, upper lip)

This seal goes on top of the transmission below the agitator drive block.

Tub bearing screw (screw)

Air duct seal (seal, air duct)

Idler pulley c-clip (ring, retaining)

Clamp

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.