41799463810 Kenmore Washer Dryer Combo Parts List

Upper lip seal (upper lid seal)

This seal goes on top of the transmission below the agitator drive block.

Cycling thermostat (control thermostat)

Tub bearing screw (screw (2))

Clamp

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.

Hinge grommet (grommet, left)

Sold individually.

Idler pulley c-clip (retaining ring)

Switch-door (door switch)

Insulator,heat shield ,outer door (heat shield)

Upper outer tub cover (splash tub cover)

Thermal lmter-330f (thermal limiter)

Pump slinger (slinger, pump)

This part is found between the pump and the motor shield and its purpose is to make sure that nothing leaks down the shaft into the transmission. Replace if washer is leaking.

Power resistor (power-resistor)

This part helps the timer advance while in the Automatic Dry cycle.

Idler sleeve (sleeve, idler pivot)

Shield-motor (motor shield)

Drum kit (drum)

This kit includes the drum, seal and high temp adhesive.