4179968020 Kenmore Washer Dryer Combo Parts List

Transmission assembly (shaft-agitator)

This part aids in the spinning and agitating cycles. The length of the shaft on this part is 13". The seal/gaskets are NOT included.

Blower housing assembly (housing-blower, front)

Blower housing foam seal (seal-blower housing)

Upper lip seal (seal-upper lip)

This seal goes on top of the transmission below the agitator drive block.

Cycling thermostat (thermostat-control)

Air duct seal (seal-air duct)

Tub bearing screw (screw-tub bearing, pph b st/z,8-12 x .75)

Clamp (clamp-drain hose)

The hose clamp is used to hold the end of the hose on to the pump to keep the hose from leaking water. If there is water leaking from the washer, the hose may be cracked or the clamp has loosened, and you will need to replace it. This part is made of metal, measures almost 2” in diameter and is sold individually. This is a genuine OEM hose clamp.

Hinge grommet (grommet-hinge)

Sold individually.

Idler pulley c-clip (ring-retaining)

Screw (screw, cr pan head, 8-32 x 0.25, theread forming)

Agitator

This agitator is straight splined and is used to shake/stir your clothes during the wash cycle.

End cap - white - left side (end cap, white, lh)

Insulator,heat shield ,outer door (shield-heat)

Screw (screw-pan hd locking, 8-32ca x 0.375, cr/sq drive)

Sold individually.