58714134100 Kenmore Dishwasher Parts List

Heating element (heater)

This part is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher and is located on the bottom of the dishwasher. Grommets are included with this part.

Door strike (strike)

This door strike is mounted to the top of the dishwasher cabinet. This part catches the door handle to keep it closed.

Rinse aid cap (rinse rinse aid cap)

This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

Upper dishrack track end cap (slide cap)

The white upper rack track stop is used to prevent the upper dish rack from sliding off the slide rail. If your rack is falling off the track, or the track stop has broken or is missing you may need to replace the track stop. This part is a genuine OEM part and is sold individually.

Kickplate grille - black (kick plate)

This part is the replacement kickplate grille or toe panel for your dishwasher. It is black in color and is approximately 7 inches by 24 inches. The kickplate grille is a decorative panel that covers up the opening at the bottom of your dishwasher. If your kickplate is damaged or missing, this is the part that will replace it. To replace the kickplate grille, simply unscrew it from the bottom of your dishwasher, then line up the new kickplate with the locator pins and screw it back into place. This part is an OEM part from the manufacturer and is sold individually.

Dishwasher water inlet tubing (tubing)

The tubing carries water from the water inlet valve to the tub.

Dishwasher filter (filter)

This filter is for dishwashers. The filter removes food particles and debris from the water to prevent the drain from clogging. Follow the instructions in the manual when installing this part.

Drain trap (trap drain)

Part is found under the lower spray arm.

Kickplate grille - black (plate)

This kickplate grille is attached to the bottom of the dishwasher.

Door handle and latch assembly - black (door latch assembly and handle)

This door latch assembly comes with the bisque handle attached.

Filter base (base)

Located at the bottom of the dishwasher, this filter keep large particles of food and foreign objects away from the pump.

Basket (silverware basket)

This is a basket for your dishwasher. It sits in the lower dishrack and holds small utensils during a washing cycle. This basket has six smaller sections where you can separate your cutlery into specific groups. This silverware holder is made entirely of plastic with a crisscross pattern allowing water and small food particles to pass through it during the cleaning process. This model is grey and roughly 14 inches long, about 6 inches high, and almost 4 inches thick.

Upper dishrack slide (upper rack slide)

This slide is mounted to each side of the upper cabinet wall. The dishrack wheels roll inside this track, which guides the upper rack. The mounting screws are not included.

O-ring - rear (o ring)

O-ring - front (o ring)