59657085790 Kenmore Refrigerator Parts List

Refrigerator kick plate grill clip (clip-grille)

This refrigerator kick plate grill is sold individually. Order two if you need to replace both clips. *Please note, if you are ordering the kick plate, check with your model number as these parts may be included.

Single roller (roller)

This wheel is sold individually. It is located on the bottom of the refrigerator.

Compression nut (nut-sleeve)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Evaporator fan motor - 115v 60hz (motor-evap fan)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Crushed ice bucket (bucket-crsh ice)

This crushed ice bucket is nineteen inches long and fourteen inches wide. It is all white in color and is made of plastic.

Screw (screw-mach)

Sold individually.

Crushed ice wheel (wheel-crsh ice)

This crushed ice wheel is five inches in diameter. It is beige in color and is made of plastic.

Single hex head screw (screw-sm)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw (screw-sm)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Screw kit (scerw-tf)

Includes 2 screws.

Screw (screw-sm)

This screw is sold individually

Plastic tubing (tube-plastic)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Defrost heater (heater-evap)

Drawer roller wheel (roller-pan)

This drawer roller wheel is all white in color and is made entirely of plastic. This wheel is used with the drawers of some refrigerators.

Refrigerator compressor start relay (relay-ptc)

The compressor start relay attaches to the compressor and helps start the compressor motor. Also knows as a start device combination relay.