59657547790 Kenmore Refrigerator Parts List

Screw (screw-sm)

This screw is sold individually

Plastic tubing (tube-plastic)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Defrost heater (heater-evap)

Refrigerator compressor start relay (relay-ptc)

The compressor start relay attaches to the compressor and helps start the compressor motor. Also knows as a start device combination relay.

Water reservoir kit (tank-water)

This kit comes with tubing and couplers.

Grommet-motor (grommet-fan)

Freezer door gasket (gasket-w fz dr)

This door gasket is approximately sixty-one and a half inches long and fourteen and a half inches wide. It is all white in color and it is made entirely of rubber. This gasket is used for the freezer of door of some side by side refrigerators.

Speed clamp clip (clip-speed)

Freezer temperature control thermostat assembly (control-temp)

This thermostat keeps a constant temperature in the freezer section of your appliance.

Roller pin (rivet)

This roller pin is used with a refrigerator's roller.

Ice maker wire harness (harness-im)

It is recommended to replace this harness when replacing the icemaker.

Door bushing - white (bushing-w top)

Sold individually.

Tube connector - 1/4 inch to 5/16 inch (tube-union)

Sold individually

Dispenser actuator arm - black (arm-w ice actr)

This includes the ice and water actuator arm.

Compressor kit (comp-tc tp 1390y)

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. This kit includes the compressor, relay, overload, drier filter, 4 pieces of tubing and mounting grommets. ***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.