59657547791 Kenmore Refrigerator Parts List

Ice stripper (stripper-ice)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Freezer door gasket (gasket-w fz dr)

This door gasket is approximately sixty-one and a half inches long and fourteen and a half inches wide. It is all white in color and it is made entirely of rubber. This gasket is used for the freezer of door of some side by side refrigerators.

Screw (screw-sm)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Screw kit (screw-tf)

Includes 2 screws.

Screw (screw-sm)

This screw is sold individually

Plastic tubing (tube-plastic)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Defrost heater (heater evap)

Refrigerator compressor start relay (relay-ptc)

The compressor start relay attaches to the compressor and helps start the compressor motor. Also knows as a start device combination relay.

Water reservoir kit (tank-water)

This kit comes with tubing and couplers.

Grommet-motor (grommet-fan)

Speed clamp clip (clip-speed)

Freezer temperature control thermostat assembly (control-temp)

This thermostat keeps a constant temperature in the freezer section of your appliance.

Roller pin (rivet)

This roller pin is used with a refrigerator's roller.

Ice maker wire harness (harness-im)

It is recommended to replace this harness when replacing the icemaker.

Chiller shelf - white (shelf-chiller)

This refrigerator chiller shelf is made of plastic and is 16 inches long. It is all white in color except for a little decorative blue detail in the front of the shelf.