59658622990 Kenmore Refrigerator Parts List

Shelf support - left side (support-l shelf)

Refrigerator kick plate grill clip (clip- grille)

This refrigerator kick plate grill is sold individually. Order two if you need to replace both clips. *Please note, if you are ordering the kick plate, check with your model number as these parts may be included.

Single roller (roller)

This wheel is sold individually. It is located on the bottom of the refrigerator.

Compression nut (nut-sleeve)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Evaporator fan motor - 115v 60hz (motor evap fan)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Crushed ice bucket (bucket- crsh ice)

This crushed ice bucket is nineteen inches long and fourteen inches wide. It is all white in color and is made of plastic.

Freezer shelf support (support-fz shelf)

This part is the replacement shelf support for your refrigerator/freezer. It is made of white plastic and is approximately 1 inch by 1 inch. The shelf support attaches to the side of your refrigerator wall and supports the shelf. If your shelf is sagging or will not stay in place, you may need to replace the support. To replace the support, use a wrench to turn the support clockwise until you can use a flat blade screwdriver to pop it out. Push the new support into the hole left by the old one until it is flush with the liner, then use the wrench to turn it clockwise until it locks in. This part is sold individually and is and OEM part.

Screw (screw-mach)

Sold individually.

Crushed ice wheel (wheel- crsh ice)

This crushed ice wheel is five inches in diameter. It is beige in color and is made of plastic.

Kickplate grille with clips (w toe grille assembly (includes clips) (58622))

White in color.

Dual water valve (valve- water (dbl))

Note: This part has been updated by the manufacturer. It may differ in appearance but will still function the same as the original.

Fresh food door gasket (ref w dr gasket assembly (includes screws and instructions))

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Single hex head screw (screw-sm)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Ice stripper (stripper-ice)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Screw (screw-sm)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.