59666022700 Kenmore Refrigerator Parts List

Freezer evaporator fan motor - 115v 60hz (motor evaporator)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will covert the heat into cool air, which is then circulated.

Fan blade

The fan blade is used to blow air over the condenser.

Defrost thermostat (thermostat)

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

Screw

This screw is sold individually.

Drawer gear kit (drawer kit)

These parts will attach to your drawer rail and are used to help the drawer glide smoothly.

Screw

Sold individually.

Defrost timer - 120v 60hz (defrost timer)

If there is ice build-up in the freezer you may need to replace the defrost timer.

Ice stripper (strips arm)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Glass shelf (glass crisper)

Shelf only. Frame not including.

Screw

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Door gasket (gasket panel)

This door gasket is for refrigerators. The door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the refrigerator. Safely store any food that could deteriorate while the door is open for this repair.

Door closer - white (closure, doo)

This part helps with the closing of the door.

Screw

This screw is sold individually

Plastic tubing (tubing)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Ice maker front cover (cover)